Bsod- Page Fault

  1. #1
    griffin is offline Newbie

    Bsod- Page Fault

    Have recently had computer upgraded into new case with new graphics card.
    Had a couple of intermittent re-boots with ms "recovery from serious error" note, but only 2 in 3 weeks. It has now started on every boot, so have followed advice from BSOD sticky on this forum. Message reads: "PAGE_FAULT_IN_NON_PAGED_AREA"
    Debuglog attached, although I note that it states in can't read some symbols? . Any help greatly appreciated.
    Attached Files
    Last edited by griffin; 31-10-2007 at 09:03 AM.


  2. #2
    peterdiva is offline Full Member
    Goto Nvidia's site and download the latest drivers for your card. Then uninstall everything that came with the video card. You want to get rid of everything related to ASUS. You don't need the ASUS stuff and it's known to cause problems. You can then install the Nvidia drivers by themselves.

    BugCheck 50, {aa83d199, 0, 8052ab28, 0}
    Probably caused by : EIO.sys ( EIO+1f49 ) <-- ASUS Smartdoctor?

  3. #3
    griffin is offline Newbie
    Thanks for info. I had installed the latest graphics driver(6.14.11) from nVidia, but had left the nforce driver as supplied. I put Asus Smart Doctor on to monitor the graphics card temp. etc, as that facility is no longer available through the nvidia control panel. Can you suggest another monitoring device, as I gather that nTune causes problems?

    Thanks

  4. #4
    griffin is offline Newbie
    Booted up ok, but crashed with BSOD after about half an hour. Debuglog still says kernal symbols are wrong! Any idea how I fix this please? New debuglog attached
    Attached Files

  5. #5
    jephree is offline ¨*·.¸ «.·°·..·°·.» ¸.·*¨
    d346bus.sys is the Daemon Tools driver.

    I would suggest removing all programs from automatically starting save your anti-virus and firewall.

    You can do this via start Run... msconfig | startup

+ Reply to Thread