Help Please if you can???????
I have an ECS P4M800PRO-M (V2.0)mother board with an Intel Core 2 Duo Processor E4300
1.80 Ghz, 800MHz FSB, 2 MB L2 Cache, Kingston 1GB PC2-4200 533MHz DDR2 memory, a
WD400 WD Caviar Enhanced IDE hard drive 40.0GB, Installed in a RaidMax Ninja (ATX-918WBP) ATX Mid-Tower with a RaidMax ATX12V power 450 W power supply.
The bios finds the hard drive but it is not reading it but after the post nothing I even went as far as repairing windows XP but still nothing happens upon booting up the OS
This hard drive was previously installed on a ECS K7S5A Pro Mainboard with an AMD Athlon processor with 2 KINGSTON 256 MB PC2100 266MHz and it was working just fine.
Thank you in advance
Just to clarify: you installed this drive as the Primary Master in this new setup? Did you verify the jumper was/is set to Master?
You would need to reinstall XP. If a Repair Install did not work then try a Clean Install.
It is the only hard drive and it is set as cable select but i will set it as the primary master and see what happens but if nothing happens then i will do a clean install and will let you know what happens'
thanks for the help
And then what happens? Can you bypass this message and start XP?
If not try Safe Mode with Command Prompt and type:
regsvr32 /u wintrust.dll
Enter then type:
regsvr32 wintrust.dll
and Enter.
I had to do another clean install and this time it worked. so thanks for all the help you have given to me
No problem. Thanks for the thanks.
Glad all is well. Let us know if we can help further in the future.