Hi Guys,
I built this little pc last week and although the motherboard, states it takes, 8 gig of ram, it is only allowing me to use just a strip of 2 gig. I tried to use another 2 in a similer colour slot, which was slot 3. But no good. I also tried to add 2 seperate strips of one gig in slots 2 and 4, but that did not work either. When I tried to boot up, it would not boot at all.

I would appreciate any help or advice I can get, thank so much.

Lucky

My specs are ;

Socket 775 motherboard - EP41-UD3L - VERSION - F4

Processor- Intel Pent R - 4632 Presler D - 3 GHZ.

WinVista

Graphics - ATI 4670

RAM = DDR 11 SDRAM 667 - part number PC2 - 6400 {400 MHZ }

Sata HD

There is probably an issue with the memory controller on the mother board if it doesn't work with different sticks of ram and considering that it is new I would take it back.

Thank you, Townsbg. I will consider that asap.

Cheers.

Lucky

Hi Townsbg,
I checked each strip out individually, and found one of the 2 x 2Gb strips was down in my gigabyte Easy tune 6 as: PC2 - 6400 - Vo1D2LF2GB18818880. This is strange, as the label on the memory stick, clearly states : PC2 -5300 - 667 MHZ. What do you think.

Lucky